Fein BOP 6 Repair Instructions page 41

BOP 6 (A); BOP 10 (A); BOP 10-2 (A); BOP 13-2 (A)
7. Fitting
Fitting the motor housing
1. Put all the electronic components in place in the housing half as shown in the first photograph.
2. Route all the cables as shown in the first photograph.
3. Fit the cable clamping piece (1) and use the screw (2) to screw it in place [0.7 Nm +0.1 Nm].
4. Fit the second housing half (3).
5. Screw in the two screws 9x22 (4) [1.2 Nm +0.2 Nm].
6. Screw in the screw 4x30 (5) [1.2 Nm +0.2 Nm].
7. Put the switch pushbutton (6) in place and use the countersunk screw (7) to fasten it [0.6 Nm +0.2 Nm].
C-SC_CSSM Version 1.0 2017-10-12 All rights reserved by FEIN, especially in case of property rights applications.
FEIN retains all rights of disposal, such as copying and circulation
5
2
3 4
1
.
6
7
Tools:
- PH1/PH2 cross-head
screwdriver
Page 41 of 65