Table of Contents
Advertisement
Installation and Set-Up
Receiving And Handling
After the machine has been uncrated, examine the
case sealer for damage that might have occurred
during transit. If damage is evident, file a damage
claim immediately with the transportation company
and also notify your 3M Representative.
Machine Set-Up
The following instructions are presented in the order
recommended for setting up and installing the case
sealer. Following them step by step will result in an
installation in your production line that best utilizes
the many features built into the case sealer. Refer
to Figure 3-1 to identify the various components of
the case sealer.
Note – A tool kit consisting of metric open
end and hex socket wrenches is provided
with the machine. These tools should be
adequate to set-up the machine, however,
other tools supplied by the customer will be
required for machine maintenance.
Figure 2-1 – Set-Up and Installation
Important – Read "Warnings" on page 16
before attempting to set-up the case sealer
for operation.
PACKAGING AND SEPARATE PARTS
STEPS 1 THRU 5
1. Lift fiberboard cover off pallet after removing
staples at bottom.
2. Use appropriate material handling equipment to
remove the machine from the pallet and move it
into position.
Whenever the machine is lifted with a fork truck,
insure that the forks span completely across the
machine frame and do not contact any wiring or
mechanism under the machine frame. In some
cases the lower taping head may need to be
removed to avoid damage.
CAUTION – Machine weighs
approximately 152 kg [335 pounds]
uncrated.
11
Advertisement
Table of Contents
