Table of Contents
Advertisement
Installation and Set-Up
3. Install the crank handle on the top of the left
column, as shown in Figure 2-1A.
4. Install the upper tape drum bracket on the top
cross bar, as shown in Figure 2-1B.
5. Remove height stop plates on both columns
(from shipping position) and re-install with
screws in lower set of holes as shown in
Figure 2-1C.
6. Install drive belt assemblies. Refer to
Figure 2-2.
a. Crank upper taping head to its fully raised
position.
b. Install drive belt assemblies on mounting
shafts with exposed belt towards inside of
case sealer and drive motor at exit end of
machine. Note – Keep drive motors in
vertical position to prevent gear oil from
leaking out of transmission.
c. Fasten drive belt assemblies in place with
spacer (A), special washer (B) and M6 x 16
flat head screw (C) on each mounting shaft.
Figure 2-2 – Drive Assemblies
(Continued)
12
d. Plug each motor cord into receptacle on
each side of case sealer bed and secure
with receptacle clamp.
Note – The drive belt assemblies can be
raised 55 mm [2.16 in] to provide better
conveying of tall boxes. Refer to "Special Set-
Up Procedure – Drive Belt Height", page 27
for set-up procedure. (Raising drive belts
increases the minimum box height that can
be taped to 115 mm [4.50 in].
TAPE DRUM BRACKET (Lower Taping Head)
Ensure that the tape drum bracket assembly is
mounted straight down, as shown in
Figure 2-3A. The tape drum bracket assembly
can be pivoted to provide clearance or for retrofit
in certain cases.
Outboard tape roll mounting (Alternate Position) –
Remove the tape drum bracket assembly, stud
spacer and fasteners from the taping head.
Install and secure on the infeed end of the lower
frame, as shown in Figure 2-3B.
MACHINE BED HEIGHT
Adjust machine bed height. The case sealer is
equipped with four adjustable legs that are
located at the corners of the machine frame.
The legs can be adjusted to obtain different
machine bed heights from 610 mm [24 in]
minimum to 855 mm [35 in] maximum.
Refer to Figure 2-3C and set the machine bed
height as follows:
1. Raise and block up the machine frame to
allow adequate leg adjustment.
2. Loosen, but do not remove, two M8 x 16
socket head screws in one leg (use M6 hex
wrench). Adjust the leg length for the
desired machine bed height. Retighten the
two screws to secure the leg. Adjust all four
legs equally.
Advertisement
Table of Contents
