Important Safeguards - 3M -Matic 800asb Instructions And Parts List

Important Safeguards

This safety alert symbol identifies
important messages in this manual.
READ AND UNDERSTAND THEM BEFORE
INSTALLING OR OPERATING THIS
EQUIPMENT.
Important – In the event the following safety
labels are damaged or destroyed, they must
be replaced to ensure operator safety. A
label kit, part number 78-8098-8966-6 is
available as a stock item or individual labels
can be ordered. See Parts Illustration/List,
Section I, pages 72 & 73.
The "Warning – Sharp Knife" label (A), shown in
Figure 1-1, is attached to both sides of the upper
frame at the location of the cut-off knife on the upper
taping heads. The "Warning – Sharp Knife" label
(B), shown in Figure 1-1, is attached to the orange
cut-off knife guard on both taping heads. The labels
warn operators and service personnel of the very
sharp knife used to cut the tape at the end of the
tape application.
Figure 1-1 – Knife Warning Label
The "Warning – Hazardous Voltage" label, shown
in Figure 1-2, is attached to the cover of the
electrical control box. The label warns service
personnel to unplug the power supply before
attempting any service work on the case sealer.
Figure 1-2 – Electrical Warning Label
The "Warning – Keep Hands Away From Moving
Belts" label, shown in Figure 1-3, is located on the
infeed end of both drive assemblies. The labels
warn operators to keep hands away from this area
when drive belts are running.
Figure 1-3 – Box Drive Belt Warning Label
3