4100-Family General Crash Codes Table (Continued) - Simplex 4100 Series Manual

2.3 4100-Family General Crash Codes Table (continued)

LCD Display
Crash Code
CRASH_SMPL_CODE_OPCODE
39 <Invalid CODE Operation>
CLASS P CRASH
CRASH_RAM_OVERLAP
62 <Overlapping CFIG RAM>
CLASS E CRASH
CRASH_MSGLIB_FMT
66 <MSGLIB Format Error>
CLASS E CRASH
CRASH_SMALL_RAM
67 <System RAM chip too small>
CLASS E CRASH
CRASH_INVALID_MSGLIB_NUMBER
73 <INVALID Msglib Number>
CLASS S CRASH
Error
Invalid operation code exists
program
Overlapping CFIG RAM
MSGLIB Format error
System RAM chip is too small
INVALID Message Library Number
Information
in
Invalid operation code exists in program
This indicates that the system RAM and the CFIG RAM
addresses overlap. This can be caused by an improper version of
the GEN_INFO.DAT file being on the CC/Build and/or Runtime
Disk.
- Message library format number is incorrect for system software
revision
- Wrong MSGLIB on programmer disk.
Use same programmer version to burn upper and lower EXEC
chips
- The amount of RAM installed in the Master Controller is too
small for the job configuration. Replace the 256K RAM with
1MEG RAM chip on 4100 and 4020, or add an additional RAM
Bank on 4100+ and UT.
- The panel did not have a RAM chip installed into U35. Remove
the chip that had been placed into the CFIG RAM socket U45
and install in the system RAM socket U35
INVALID Message Library Number
Page 28 of 60