Designated Use; Disposal Remarks - Trotec Speedy 300 fiber Operation Manual

8017 Trotec Speedy 300 fiber
GENERAL

1.2 Designated Use

The Trotec Speedy 300 fiber is used for marking on metals and plastics. Many metals and
most plastics will show interaction with the laser beam. However, very clean metallic
surfaces which are highly polished and pure could show NO reaction. This is due to too
high reflectivity at 1064nm wavelength which is given especially for silver and copper.
The working process must only be performed with a perfectly adjusted
machine (see also Section 4 OPERATION).
Use of the system in other areas is against the designated use. The
manufacturer does not admit liability for damage to personal and/or
equipment resulting from such use.
The system must only be operated, maintained and repaired, by personnel
that are familiar with the designated field of use and the dangers of the
machine!
Non-observance of the instructions for operation, maintenance and repair
described in this Operation Manual excludes any liability of the manufacturer if
a defect occurs.
Caution when processing conductive materials (carbon fibers...)! Conductive
dust or particles in the ambient air might damage electrical components and
lead to short circuits. Bear in mind that those defects are NOT warranted.

1.3 Disposal remarks

Do not dispose the machine with domestic waste!
Electronic devices have to be disposed according to the regional directives
on electronic and electric waste disposal.
In case of further questions, please ask your supplier. He might take care of
proper disposal.
28/07/2015 Trotec Produktions- und Vertriebs GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto: techsupport@troteclaser.com
6 / 54