Table of Contents
Advertisement
8017 Trotec Speedy 300 fiber
OPERATION
4.3 Keypad
1
POSITIONING KEYS Z
When pressing one of these two keys the working table moves in
Z direction (upwards or downwards).
Use these positioning keys to move the work piece manually.
When both keys are pressed simultaneously, the material is focused
automatically (only with light barriers = option).
Before the autofocus- move is started, the head is moved backward in
line with the light barriers. If the light barrier is broken, e.g. by an air
assist nozzle, the upward move will be suppressed to prevent a
collision between the nozzle and the table.
The Autofocus option might not work on transparent materials or
materials which are not flat.
Bear in mind that defects from head crashes (working head hits
material or working table) are NOT warranted.
By pressing the "Shift" key and a Z- positioning key an automatic move
to the corresponding end- positions is performed:
Shift + Down: the table moves down to the lowest possible position
Shift + Up: the table moves up to the autofocus- position.
Note: Shift + Up will cause the head moving backwards to the light
barriers (according simultaneous pressing of both z-keys).
If any of positioning keys X and Y is pressed, no moves in Z are
possible.
An automatic move of the Z- axis can be stopped by pressing of
the positioning keys (1 or 2).
28/07/2015
Trotec Produktions- und Vertriebs GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto:
5
4
6
7
8
9
3
2
1
techsupport@troteclaser.com
29 / 54
Advertisement
Table of Contents
