Table of Contents
Advertisement
8017 Trotec Speedy 300 fiber
SAFETY
Preparation, retooling, change of work piece, maintenance and repair activities must only
performed with equipment switched off, by trained personnel.
It is forbidden to perform unauthorized modifications and changes to the machine. It is
emphasized, that any unauthorized modifications to the machine are not permitted for safety
reasons.
2.2 Laser Safety Information
To assess the potential dangers laser systems pose, they are classified into 5
safety classes: 1, 2, 3a, 3b and 4. Trotec Speedy 300 fiber is a device of
class 2 (USA: Class II). This is guaranteed by the protective housing and the
safety installations.
Please note that improper operation of the device can override the status of
safety class 2 and can cause the emission of harmful radiation.
This laser system contains an YTTERBIUM FIBER LASER of class 4 that
emits intensive and invisible laser radiation. Without safety precautions the
direct radiation or even diffuse reflected radiation is dangerous!
Without safety precautions, the following risks exist with exposure to laser
radiation:
Eyes:
Skin:
Clothing:
Never try to modify or disassemble the laser and do not try to start up a
system that had been modified or disassembled!
Dangerous radiation exposure can result from the use of operation or
adjustment equipment other than that described here, and if different
operational methods are performed.
Service technicians using the service plug are required to wear standard laser
safety glasses for NIR (Near Infra Red) LASER lasers (wavelength
1060 nm).
28/07/2015
Trotec Produktions- und Vertriebs GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto:
Burns to the retina for NIR (Near Infra Red) LASER
Burns
Danger of fire
techsupport@troteclaser.com
11 / 54
Advertisement
Table of Contents
