Panasonic DVCPRO HD AJ-HDC27VP Service Manual page 608

5-15. Tension Arm Unit
Replacement
(Removal)
1. Remove the Cut Washer (A) and hang off the
Tension Regulator Spring, and then remove the
Tension Arm Unit as shown in Figure 5-15.
(Installation)
1. Install the new Tension Arm Unit following the
removal steps in reveres order.
2. After installation, Tension Arm Adjustment should
be performed the following steps.
Figure 5-15
<Tension Arm Adjustment Flow Chart>
4-3. Tension Arm Offset Voltage Adjustment
4-4. Tension Arm Neutral Position Adjustment
4-5. Tension Arm PLAY Voltage Adjustment
4-6. Tension Arm REV Voltage
4-6. Tension Arm Tension Regulator
4-7. REV Tension Confirmation
MECH-41
START
Confirmation
Spring Adjustment
& Screw Lock
END
NG
NG