Version Upgrade For Vtr_Sys P.c.board - Panasonic DVCPRO HD AJ-HDC27VP Service Manual

16-3. Version Upgrade for VTR_SYS P.C.Board

16-3-1. Connection
1. Connect RS-232C Cable between connector P2 on VFK1304A and COM1 port on PC. (Refer to Figure. 16-
2.)
2. Connect Flat cable between connector P1 on VFK1304A and connector P6100 on VTR_SYS P.C.Board,
and then set SW1 on VFK1304A according to Figure. 16-1.
3. Turn on the power of the unit and then boot-up PC (WINDOWS mode).
16-3-2. Software Version Upgrading
1. Copy all files of VFK1248E to arbitrary directory.
2. Double-click the program file icon "VSI2312E.EXE".
3. When this Software is started, a dialog will be opened as shown below.
4. Set parameters on "Setup Panel" window.
Microcomputer select............................. M32160F4UFP
Writing data ............................................ File data
Enter new version-up data name (XXXX.mot) with full path. You can also use "Browse..." button on
the "Setup panel" to select the file name and location of the new version-up data.
Target machine ID check ....................... Off
Port ......................................................... Set the port which RS-232C Cable is connected to PC.
Baud Rate .............................................. 115200
Stop Bits ................................................. 1Bit
Byte Size ................................................ 8Bits
Parity ...................................................... None
INF-35