Adjustment After Optical Unit Replacement; Input The Adjustment Data; Electrical Adjustment - Panasonic DVCPRO HD AJ-HDC27VP Service Manual

10. Adjustment after Optical Unit Replacement

When replace the Optical Unit (PRE AMP, CCD
PULSE, DRIVE Board
adjustment as following procedures.
In this case, do not need to execute the Optical Unit
Adjustment on the "Section 5 : Electrical Adjustment".

10-1. Input the Adjustment Data

1. Set the Shading Correction to "OFF" as follows.
*** CAM MAIN MENU 4 ***
< BLACK SHADING >
® CORRECT (DIG)
< WHITE SHADING >
® CORRECT
2. Input the adjustment data following the Adjustment
Data Sheet which is included with optical unit.
< Items mentioned on the Adjustment Data Sheet >
(8 items)
*** CAM DESIGN MENU ***
< VDRIVE 1 >
® R-SUB
® G-SUB
® B-SUB
*** CAM DESIGN MENU ***
< VDRIVE 2 >
® H1-DC
® VSHIN
3. Input or execute the following setting by menu.
(Memory of Setting Value)
*** CAM DESIGN MENU ***
< LSI REG SET 1 >
® ADR_H
: "FF" (input)
® ADR_L
: "01" (input)
® WRITE : "OFF" ® "ON" (execute)
included), execute the
: "ON" ® "OFF"
: "ON" ® "OFF"
® R-RESET DC
® G-RESET DC
® B-RESET DC

10-2. Electrical Adjustment

Execute the Confirmation and Adjustment as following
items. (Refer to "Section 5 : Electrical Adjustment")
1. 0IRE PED Adjustment
2. R,G,B PRE AMP DC Confirmation
3. R,G,B PULCAN Adjustment
4. R,G,B PREPRO Level Confirmation
5. R,G,B PED TRACK Adjustment
6. Modulation Confirmation
7. R,G,B W/S (WHITE SHADING) OFFSET Adj.
8. Digital W/S (WHITE SHADING) Adjustment
9. Digital D/S (DARK SHADING) Adjustment
10. FLARE Adjustment
11. R,B GAMMA Adjustment
INF-23