Panasonic DVCPRO HD AJ-HDC27VP Service Manual page 52

II ) When compensation is fully impossible
In this case, there are two solutions by manual compensation.
a ) Re-setup of PICKUP LEVEL
1. Open "<ENTRY (AUTO)>" page in CAM SERVICE level.
2. Re-Setup "PICKUP LEVEL R/ G or B" items to level down (down detection level).
3. Execute automatic compensation again. (Set "START" item in "<ENTRY (AUTO)>" page to ON.)
b ) Fine adjustment of cursor position
1. Open "<EDIT / DELETE>" page in CAM SERVICE level.
2. Select Defect number desired position of fine cursor adjustment by "DEFECT NO." item.
3. Set "DELETE" item to ON (turn JOG DIAL) and then press JOG DIAL.
4. Open "<ENTRY (MANUAL)>" page in CAM SERVICE level.
5. Set menu items are shown below.
DEFECT SIZE
GAIN
6. Set "DEFECT COLOR" item to R / G / B or Y, according to color of blemish. (When two or more color of
blemish appear in the same position, select "Y".)
7. Observe TV-monitor and then adjust "H CURSOR COARSE and FINE" item so that the H cursor position
comes to target blemish.
8. Observe TV-monitor and then adjust "V CURSOR COARSE and FINE" item so that the V cursor position
comes to reduce the blemish.
9. Set "ENTRY" item to ON (turn JOG DIAL) and then press JOG DIAL.
10. When "ENTRY" character appears on the lower right of the screen, data store will be completed.
11. Close menu screen and then turn off the power of the Unit.
: 3
: OFF
<ENTRY (MANUAL)>
® ® ® ® H CURSOR COARSE
H CURSOR FINE
V CURSOR COARSE
V CURSOR FINE
DEFECT SIZE
DEFECT COLOR
GAIN
OFFSET LEVEL A
OFFSET LEVEL B
ENTRY
CANCEL
Figure Ble-5 ENTRY (MANUAL) page
INF-43
: 03
: 80
: 02
: 80
: 3
: Y
: OFF
: 100
: 100
: OFF
: OFF