Panasonic DVCPRO HD AJ-HDC27VP Service Manual page 476

1-3. R, G, B Response
Confirmation
BOARD
-----
TP
SDI OUT (G,B,R) 75ohm termination
ADJUST
Service Menu
F NUMBER
OPEN (2000LUX)
MODE -----
CHART Gray Scale Chart
M. EQ
WFM
SPEC.
Stable response against level change.
< Menu >
*** CAM DESIGN MENU ***
<VDRIVE 1>
⇒ R RESET DC
⇒ G RESET DC
⇒ B RESET DC
1. Repeat opening and closing the iris quickly and
confirm the response. (Poor response takes a
longer delay time after level is changed.)
2. If the response is poor need fine adjustment of R,
G and B RESET DC (increase value).
Open the IRIS Close the IRIS
ELE-2
1-4. H1DC Adjustment
BOARD -----
TP
SDI OUT (G,B,R) 75ohm termination
ADJUST
Service Menu
F NUMBER F11-1/2 (2000LUX)
MODE -----
CHART Gray Scale Chart
M. EQ WFM, Color Monitor TV
SPEC.
Adjust to eliminate H blurs. And then set
-10.
< Menu >
*** MAIN MENU 1 ***
<CAMERA SETTING>
⇒ GAMMA
1. Set the GAMMA of the CAMERA SETTING page
to ON.
2. The H1DC of the VDRIVE1 page is set to "80" and
then confirm that the H Blurs appears or not.
If the H Blurs appear, adjust H1DC of the
VDRIVE1 page so that H Blurs is just disappeared.
And then set the value of H1DC minus 10.
Note:
The adjustment value of the menu is a hexadecimal
number display.
***CAM DESIGN MENU***
<VDRIVE 1>
⇒ H1DC
H Blurs
(Luminance and color
smear in horizontal
direction)