Hydronix Hydro-Control VI Installation Manual page 60

System Design
Upgrading Hydro-Control V installations
3.3
The Hydro-Control VI has been designed to be a direct replacement for a Hydro-Control V. The
connectors for the I/O will accept the same connectors that the Hydro-Control V uses, with the
same pin out. Care should be taken to insert the connectors correctly so that the cut-outs for
the connector keys match the connectors themselves.
The Hydro-Control VI Utility is an additional software tool that runs on a PC that can be used to
convert a backup from a Hydro-Control V system allowing the recipes and system parameters
to be copied to a Hydro-Control VI.
60 Hydro-Control VI Installation Guide HD0455 Rev 1.9.0
Chapter 5