Hydronix Hydro-Control VI Installation Manual page 20

Mechanical Installation
6 Touch screen protective layer
The touch screen has a thin sheet of plastic which protects it. The sheet is not glued in place, but
held around the edged by the bezel on the front of the Hydro-Control. If the protector gets worn or
dirty it can be replaced with Hydronix Part Number 0179.
The touch screen protective layer can be removed by carefully applying pressure to the front of the
Hydro-Control and sliding the sheet down slightly. This will expose the corners of the sheet which
can then be lifted away from the touch screen. A blunt plastic tool can also be used to help lift the
sheet if needed.
To fit a new sheet, remove the sheet from the packaging taking care to keep the sheet clean and
dust free. Remove the protective covering from the rear (shiny) surface of the touch screen
protector and then carefully fit the new protector over the screen so that the anti-glare (dull) front
surface faces away from the touch screen.
20 Hydro-Control VI Installation Guide HD0455 Rev 1.9.0
Chapter 2