Table of Contents
Advertisement
◆Trip Distance Clearance
Clear Trip means trip distance clearance. Press the UP or DOWN button to choose
YES or NO. The default value is NO.
To clear a trip, choose YES and press the ON/OFF button to confirm. The screen
says 'OK' and returns to the G eneral Settings interface.
◆Unit Mile/KM toggling
Set Unit represents unit settings. The default value is Metric 'KM'
To toggle unit, press UP/DOWN until the desired unit is displayed.
To store a changed setting, press the ON/OFF button to confirm. T he screen says
'OK' and then returns to G eneral Settings interface .
◆Wheel Diameter Settings
Set WD represents wheel diameter settings. Optional values are 16, 18, 20, 22, 24,
26, 700C and 28. The default value is 26 inch.
To change basic settings, press UP/DOWN to increase or decrease until the
desired value is displayed.
To store a changed setting, press the ON/OFF button and the screen says 'OK'
and then returns to G eneral Settings interface .
General Settings interface
Trip distance clearance
Mile and Kilometer Toggling Interface
Wheel Diameter Settings Interface
5
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the KD58C and is the answer not in the manual?
Questions and answers
My KD58C display only goes to P4 and the password request. I can’t get into the settings as none of the suggested passwords work.
To reset the password for the Key-Disp KD58C display, follow these steps:
1. Access the settings by holding the ON/OFF button for 2 seconds.
2. Navigate to the power-on password settings (P2:0000).
3. Use the UP/DOWN buttons to modify the digits of the password.
4. Press the ON/OFF button to confirm each digit until the new 4-digit password is entered.
5. Once the password is set, press the ON/OFF button to save and exit.
If you are unable to recall the existing password, you may need to recover default settings by:
1. Pressing the UP and ON/OFF buttons simultaneously for 2 seconds.
2. Selecting Y (Yes) using the UP/DOWN buttons to confirm resetting to default settings.
3. Holding the ON/OFF button for 2 seconds to reset, returning the password to its default value (1212).
This answer is automatically generated
I can not get the unit to power on at all. Battery is fully charged and turned on.
The Key-Disp KD58C may not power on despite a fully charged battery due to several reasons:
1. Power-on Password Enabled: If the power-on password is enabled, you must enter the correct password to turn on the display.
2. Connection Issues: Ensure the connector is properly linked and secure, as improper connection can prevent power from reaching the display.
3. Error Codes: Check for any error codes on the display (e.g., Error Code 30 for communication abnormality) that may indicate a malfunction.
4. Display Malfunction: If the display is not functioning properly, it may need repair.
If all these checks are in order and the display still does not power on, consider troubleshooting the electrical connections or seeking repair.
This answer is automatically generated