Table of Contents
Advertisement
◆Switching Push-assistance Mode On/Off
To activate the push-assistance function, press and hold the DOWN button. After 2
seconds, the E-bike will go on at a uniform speed of 6 Km/h and "P" is shown on the
screen at the same time. The push-assistance function is switched off as soon as you
release the DOWN button.
■Push-assistance function may only be used when pushing the E-bike. Be
aware of danger of injury when the wheels of E-bike do not have ground contact
while using push-assistance function.
◆Switching the Lighting On/Off
To switch on E-bike lights, hold the UP button for 2s. The E-bike lights will be
switched on while display backlight darkens.
Likewise, hold the UP button for 2s again, the E-bike front light will be switched off
while display backlight recovers the brightness.
■
If E-bike lights are independent of "UP" button, the "UP" button can only be used to
switch on/off the display backlight.
◆assist Level options
Assist levels indicate the output power of the motor. The default value is level "1".
The default power ranges from level "0" to level "5".The output power is zero on
Level "0". Level "1" is the minimum power. Level "5" is the maximum power.
Press UP/DOW to change the assist level.
Display indication cycle interface
Push-assistance Mode
Switch the Lighting on/off
3
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the KD58C and is the answer not in the manual?
Questions and answers
My KD58C display only goes to P4 and the password request. I can’t get into the settings as none of the suggested passwords work.
To reset the password for the Key-Disp KD58C display, follow these steps:
1. Access the settings by holding the ON/OFF button for 2 seconds.
2. Navigate to the power-on password settings (P2:0000).
3. Use the UP/DOWN buttons to modify the digits of the password.
4. Press the ON/OFF button to confirm each digit until the new 4-digit password is entered.
5. Once the password is set, press the ON/OFF button to save and exit.
If you are unable to recall the existing password, you may need to recover default settings by:
1. Pressing the UP and ON/OFF buttons simultaneously for 2 seconds.
2. Selecting Y (Yes) using the UP/DOWN buttons to confirm resetting to default settings.
3. Holding the ON/OFF button for 2 seconds to reset, returning the password to its default value (1212).
This answer is automatically generated
I can not get the unit to power on at all. Battery is fully charged and turned on.
The Key-Disp KD58C may not power on despite a fully charged battery due to several reasons:
1. Power-on Password Enabled: If the power-on password is enabled, you must enter the correct password to turn on the display.
2. Connection Issues: Ensure the connector is properly linked and secure, as improper connection can prevent power from reaching the display.
3. Error Codes: Check for any error codes on the display (e.g., Error Code 30 for communication abnormality) that may indicate a malfunction.
4. Display Malfunction: If the display is not functioning properly, it may need repair.
If all these checks are in order and the display still does not power on, consider troubleshooting the electrical connections or seeking repair.
This answer is automatically generated