Broadcast
Network
Configuration
Virtual Interfaces
Click Add to add a virtual interface. Click on the remove to remove the virtual interface.
Object – Virtual
Server
AP Isolation
Save your changes after changing the "Wireless Mode". For "Wireless Network Mode", "Wireless
Width", or "Broadband" option, click on the button you prefer to configure.
4.3.2.2. Wireless Security
Wireless security option is used to configure the security of your wireless network. This route has a total of seven kinds
of wireless security mode. Disabled by default, not safe mode is enabled. For changes in Safe Mode, click Apply to
take effect immediately.
WEP
It is a basic encryption algorithm that is less secure than WPA. Use of WEP is discouraged due to security weaknesses,
and one of the WPA modes should be used whenever possible. Only use WEP if you have clients that can only support
WEP (usually older, 802.11b-only clients).
IP address needs to be manually configured when unbridged is selected
Description
This setting isolates wireless client so access to and from other wireless
clients are stopped.
53