Cellular Gateway Upper Panel; Wiring The Power Inputs - Planet ICG-2510W-LTE Series User Manual

 10/100/1000BASE-T LAN Port Interfaces (Port-1 to Port-4)
LED Color
Ethernet Green
 10/100/1000BASE-T WAN Port Interface
LED Color
Ethernet Green

2.1.3. Cellular Gateway Upper Panel

The upper panel of the Industrial Cellular Gateway
upper panel of the Cellular Gateway.

2.1.4. Wiring the Power Inputs

The 2-contact terminal block connector on the top panel of Industrial Cellular Gateway is used for one DC power input.
The power input range is from 9 to 36V DC. Please follow the steps below to insert the power wire.
1. Please read the above description of upper panel carefully before inserting positive/negative DC power wires
into the 2-contact terminal block connector.
2. Confirm that the positive/negative DC power wires will not fall off.
Lights Indicates that the link is successfully established.
Blinking Indicates that the port is actively sending or receiving data.
Lights Indicates that the link is successfully established.
Blinking Indicates that the port is actively sending or receiving data.
consists of three terminal block connectors.
Figure 2-4: ICG-2510W(G)-LTE Series Upper Panel
Figure 2-5: Wiring the Power Inputs
Function
Function
21
Figure 2-4 shows the
Power
Input