DT9502
Access is possible
by supervisor code only
Access is possible
by supervisor code only
20171205-V3
10.5. Description of the menu items
You find a description of the menu items in the following
part. A description on the handling of the menu is in Chapter
7. Settings.
Display modes of limit output status (Limit Displaying)
[Default Factory Setting: OFF]
•
Switched off (OFF)
It never displays the limit output status.
•
Dynamic button (Dynamic Button)
As long as the ENTER is being pressed down.
•
Timed button (Timed Button)
As long as the ENTER is being pressed down + for 2.5
seconds.
•
Static button (Static Button)
The display can be switched ON/OFF by ENTER.
•
Automatically: when changes (Auto: Change)
For a period of 2.5 sec, after a change has taken place in
the output. Disabling: by ENTER
•
Automatically: periodical (Auto: Periodical)
Periodical: ON/OFF in each 2.5 seconds. Disabling: by
ENTER.
•
Always ON (ON)
Disabling: by ENTER.
Limit output configuration sub-menu No.1.(Limit 1)
Detailed description in the chapters 7.3., 7.4., 7.5.
Limit output configuration sub-menu No.2. (Limit 2)
It is the same as for limit output No.1., but everything
pertains to limit output No.2. Detailed description in the
chapters 7.3., 7.4., 7.5.
4 wiring / 3 wiring measuring metod (WirE)
Must set to conformable with effective swathe metod Pt 100.
[Default factory setting: 4 wiring.]
The temperature value belonging to 4 mA
Any value may be assigned to it within the temperature
interval displayable on the display [Default factory setting:
-200.0 °C]
67