Table of Contents
Advertisement
DT9502
Access is possible
by supervisor code only
Access is possible
by supervisor code only
Access is possible
by supervisor code only
Access is possible
by supervisor code only
Access is possible
by supervisor code only
20171205-V3
Changing the Supervisor Code (Supervisor Code)
The new Supervisor Code must be typed in twice, in order
to avoid any typing errors. The mnemonic
Type) warns you to type the code for the second time, after
you have typed it once. If the two codes are not identical
with each other, the mnemonic
on the display, and the instrument exits the menu item.
Make sure not to forget the Supervisor Code, otherwise a
new one can be defined in the service only. [Default factory
setting: 100]
Display mode (LCD)
•
: four-and-a-half-digit mode (-19999 - 19999).
•
: three-and-a-half-digit mode (-1999 - 1999).
[Default factory setting: four-and-a-half-digit]
Disable displaying leader zeros (Leader Null)
•
•
one standing before the integer [Default factory setting:
leader zeros are displayed]
Erase of min. / max. value (Reset Min. & max.)
choosing erases min. and max. values
Restoring the default settings (Reset 1)
When you select
the default factory setting, and the instrument restarts.
It is not possible to withdraw this command subsequently!
: the leader zeros are displayed
(Space): the leader zeros are not displayed, only
, all the parameters will be reset to
(Bad Code) appears
(Re-
69
Advertisement
Table of Contents
