Table of Contents
Advertisement
Hysteresis of the low
limit
Sequence of operations
High limit value
Sequence of operations
34
17. Enter by pressing the ENTER button.
18. You see this
on the display. This is the value of L1.LH. It can be
changed between 000 and 999. The digit at the left side is
blinking.
19. Pressing ► button you can select the next digit.
20. Pressing ▲ button you can increase the value of the
blinking digit:
,
,
,
,
21. After you have set the value of the hysteresis, press the
MENU button to exit from the sub-menu item, and you see
this:
.
22. If you had selected the
operating mode, there is no need to do further settings. For
finishing the operation, go on with the steps from the part:
Exit from the menu item.
Setting the high limit value and It's hysteresis is necessary
in that case only, if you had selected the
operating mode.
23. Pressing the ▲ button keep stepping as long as you see
this sub-menu item:
high limit value. Here you can define the higher numerical
value, to which the instrument compares the measured
physical values.
24. Enter by pressing the ENTER button.
25. You see this
is blinking in the upper left corner. The arrow indicates that
the uppermost digit (the „half" digit) is being selected from
the 4 and half digits, and now it can be modified by pressing
the ▲ button.
,
,
,
,
,
or the
. HL (High Limit) means: the
on the display, and the arrow (
DT9502
, etc.
limit-value
or the
20171205-V3
←
)
Advertisement
Table of Contents
