Table of Contents
Advertisement
Setting the operating
mode
Sequence of operations
Low limit value
Sequence of operations
32
6. After you have selected the desired operating mode for
the limit output, press the MENU button. This takes you out
from the given sub-menu item, and you see this:
7. If you had selected the
need to do any further settings. For finishing the operation,
please go on from the point Exit from the menu item.
8. Keep stepping by pressing the ▲ button as long as you
see this sub-menu item:
low limit value. Here you can define the numerical value by
which the device will compare the measured physical
values.
9. Enter by pressing the ENTER button.
10. You see this
is blinking in the upper left corner. The arrow indicates that
the uppermost digit (the „half" digit) is being selected from
the 4 and half digits, and now it can be modified by pressing
the ▲ button.
11. Pressing the ► button you can select the next digit.
12. Pressing the ▲ button you can increase the value of the
blinking digit:
,
,
,
,
13. When the last digit (right-side) is being selected, and
you press the button ►, a blinking colon appears on the left
side:
. The colon indicates that the plus/minus
sign is being selected, and it can be modified by pressing
the ▲ button.
or the
. LL (Low Limit) means: the
on the display and the arrow (
,
,
,
,
,
DT9502
mode, there is no
←
, etc.
20171205-V3
.
)
Advertisement
Table of Contents
