Table of Contents
Advertisement
Example:
Hysteresis = 0
Figure:
Hysteresis > 0
Figure:
Hysteresis > 0
76
Comment: the precondition for the following examples is
that the output is in
the measured value ≥ L1.LL (low limit).
The input signal has an increasing characteristic, but
rippled.
value = 100.0 °C.
The value of the relevant hysteresis (
A hysteresis with a value of zero means that the limit
detection has no hysteresis. The output switches ON when
the value on the display reaches or is in excess of
°C, and switches OFF when it goes lower than
again.
The following figure shows the essentials of hysteresis,
when it's value is higher than zero
The following figure shows the essentials of hysteresis,
when it's value is higher than zero
mode, that is, it switches ON when
DT9502
) = 0 °C.
°C
20171205-V3
Advertisement
Table of Contents
