Suzuki Baleno Manual page 428

EMERGENCY SERVICE
Emergency repair
1) Place the vehicle on level, hard ground.
Set the parking brake firmly and shift
into "P" (Park) if your vehicle has an
automatic transaxle or CVT, or shift into
"R" (Reverse) if your vehicle has a
manual transaxle.
Turn on the hazard warning flasher if
your vehicle is near traffic.
Block the front and rear of the wheel
diagonally opposite of the wheel being
repaired.
2) Take out the sealant bottle and the
compressor.
3) Screw the bottle into the socket of the
compressor.
4) Unscrew the valve cap from the tire
valve.
5) Connect the filler hose of the sealant
bottle to the tire valve.
6) Connect the power plug of the com-
pressor to the accessory socket. Start
the engine. Switch on the compressor.
Inflate the tire to the required air pres-
sure.
8-7
10 min. Max.
(2)
required
air pressure
(3)
(4)
68PM00807
(1) Tire valve
(2) Filler hose
(3) Compressor
(4) Power plug
NOTICE
Do not operate the compressor for
longer than 10 minutes. It can cause
overheating of the compressor.
If the tire cannot be inflated to the required
air pressure within 5 minutes, move the
vehicle a few meters back and forth to
spread the sealant over the entire tire.
Then, inflate the tire again.
If the tire still cannot be inflated to the
required air pressure, the tire may be
severely damaged. In this case, the flat tire
repair kit cannot provide the necessary
seal. Consult a SUZUKI dealer or a road-
side assistance service.
NOTE:
If the tire is over-inflated, deflate air by
loosening the filler hose.
7) Switch off the compressor. Pull out the
power plug from the accessory socket.
8) Disconnect the filler hose of the sealant
bottle from the tire valve.
9) Push the release button on side and
detach the sealant bottle.
(1)
(5)
(5) Release button
68PM00808
68PM2-01E