Suzuki Baleno Manual page 165

START
Manual transaxle – Provided you have the
keyless push start system remote control-
ler with you, the engine automatically
starts when you press the engine switch to
select this ignition mode after shifting to
"N" (Neutral) and depressing the brake and
clutch pedals.
Automatic transaxle or CVT – Provided
you have the keyless push start system
remote controller with you, the engine
automatically starts when you press the
engine switch to select this ignition mode
after placing the gearshift lever in "P" posi-
tion and depressing the brake pedal. (If
you need to re-start the engine while the
vehicle is moving, shift into "N".)
NOTE:
You do not need to keep the engine switch
pressed to start the engine.
NOTICE
Do not leave the engine switch in
"ACC" or "ON" mode when the
engine is not running. Avoid using
the radio or other electric accesso-
ries for a long time when the engine
switch is in "ACC" or "ON" mode
when the engine is not running, oth-
erwise the battery may discharge.
NOTE:
In the presence of strong radio signals or
noise, you may not be able to change the
ignition mode to "ACC" or "ON" or to start
the engine using the engine switch. In this
case, the information display in the instru-
ment cluster will show the following mes-
sage: KEY FOB NOT DETECTED.
OPERATING YOUR VEHICLE
Unreleased steering lock warning
If the steering lock remains engaged when
you press the engine switch to change the
ignition mode to "ON", the information dis-
play in the instrument cluster shows the
message: "TRN. STEERING WHEEL TO
RELEASE LOCK". Refer to "Information
display" in "BEFORE DRIVING" section for
details.
NOTE:
The steering lock may not be released if
some load is acting on the steering wheel.
If this happens, turn the steering wheel to
the right or left to relieve it from the load
before you press the engine switch again
to change to the desired ignition mode.
68PM2-01E
3-6