Suzuki Baleno Manual page 196

OPERATING YOUR VEHICLE
When decelerating (Traveling at approx-
imately 15 km/h (9 mph) or below)
• The hood is opened.
• The vehicle increases the speed caused
by a slope (#).
When stationary
• The driver releases the seat belt (#).
• The driver's door is opened (#).
• The vehicle starts to move on a slope,
etc. (#).
• Some time (3 minutes or so) has
elapsed after the start of the automatic
engine stop (#).
# The "ENG A-STOP" indicator (green)
will blink and then go off.
3-37
"ENG A-STOP OFF" switch
The ENG A-STOP system can be deacti-
vated.
• To deactivate the system, press the
"ENG A-STOP OFF" switch (1) to turn on
"ENG A-STOP OFF" indicator (2).
• To enable the system once again, press
the switch (1) again to turn off the indica-
tor.
• Every time the engine is stopped manu-
ally, the system is enabled again and the
"ENG A-STOP OFF" indicator (2) goes
off.
(1)
68PM00320
NOTE:
Pressing the "ENG A-STOP OFF" switch
(1) during the automatic engine stop will
restart the engine automatically and the
"ENG A-STOP OFF" indicator (2) will come
on.
"ENG A-STOP OFF" indicator
This indicator comes on in the information
display.
• This indicator comes on when the ENG
A-STOP system is deactivated.
• The indicator blinks when the engine
switch is pressed to change the ignition
(2)
mode to "ON", if one of the conditions
listed below is met.
The ENG A-STOP system or the SHVS
system does not actuate correctly while
the indicator is blinking. Have the system
inspected by an authorized SUZUKI
dealer.
– There may be something wrong with
the ENG A-STOP system or the SHVS
system.
– An engine component (starter) or the
battery is due for replacement.
NOTE:
If the indicator blinks during the automatic
engine stop, the engine may shut down.
68PM00317
68PM2-01E