Suzuki Baleno Manual page 429

10)Affix the speed restriction label from the
sealant bottle in the driver's field of
view.
11)Make a short drive immediately after
inflating the tire to the required air pres-
sure. Drive carefully with a maximum
speed of 80 km/h (50 mph).
12)Carry on driving carefully to the nearest
SUZUKI dealer or a tire repair shop.
WARNING
Do not affix the speed restriction
label to the air bag. Also do not affix
it to the warning light indicator or to
the speedometer.
13)After driving for up to 10 minutes, check
the tire pressure with the pressure
gauge of the compressor. If the air
pressure indicates more than 200 kPa
(2.0 bar), the emergency repair is com-
pleted. But, if the air pressure indicates
less than the required air pressure, cor-
rect the tire pressure to the required air
pressure. If the tire pressure has
dropped below 130 kPa (1.3 bar), the
flat tire repair kit cannot provide the
necessary seal. Do not use the tire and
consult a SUZUKI dealer or a roadside
assistance service.
WARNING
Check the tire pressure and confirm
the completion of the emergency
repair after driving for up to 10 min-
utes.
NOTICE
Have the tire renewed at the nearest
SUZUKI dealer. When reusing the
sealed tire, consult a tire repair shop.
The wheel can be reused after wiping
sealant off completely with cloth in
order to prevent rust, but the tire
valve and tire pressure monitoring
system (TPMS) sensor must be
renewed.
Dispose of the sealant bottle at a
SUZUKI dealer or in accordance with
your regional codes and practices.
After using the sealant bottle, replace
it with a new bottle from your SUZUKI
dealer.
EMERGENCY SERVICE
Using compressor to inflate a tire
1) Place the vehicle on level, hard ground.
Set the parking brake firmly and shift
into "P" (Park) if your vehicle has an
automatic transaxle or CVT, or shift into
"R" (Reverse) if your vehicle has a
manual transaxle.
2) Take out the compressor.
3) Unscrew the valve cap from the tire
valve.
4) Connect the air hose of the compressor
to the tire valve.
5) Connect the power plug of the com-
pressor to the accessory socket. Start
the engine. Switch on the compressor.
Inflate the tire to the required air pres-
sure.
NOTICE
Do not operate the compressor for
longer than 10 minutes. It can cause
overheating of the compressor.
68PM2-01E
8-8