Suzuki Baleno Manual page 108

BEFORE DRIVING
Instantaneous fuel consumption
The display shows instantaneous fuel con-
sumption with a bar graph only when the
vehicle is moving.
EXAMPLE
(4)
68PM00280
(4) Instantaneous fuel consumption
NOTE:
• The display does not show the bar graph
unless the vehicle is moving.
• Depending on the vehicle's specification,
the fuel consumption units of initial set-
ting are indicated as L/100km, km/L or
MPG.
• For L/100km or km/L setting, the indi-
cated maximum value of instantaneous
fuel consumption is 50. No more than 50
will be indicated on the display even if
the actual instantaneous fuel consump-
tion is higher.
2-89
• For MPG setting, the indicated maxi-
mum value of instantaneous fuel con-
sumption is 80. No more than 80 will be
indicated on the display even if the
actual instantaneous fuel consumption is
higher.
• The indication on the display may be
delayed if fuel consumption is greatly
affected by driving conditions.
• The display shows estimated values.
Indications may not be the same as
actual values.
Average fuel consumption / 5-minute
average fuel consumption
Average fuel consumption from previous
reset and 5-minute average fuel consump-
tion are shown.
(Average fuel consumption)
EXAMPLE
(5)
(5)
68PM00281
(5) Average fuel consumption
If you selected average fuel consumption
the last time you drove the vehicle, the dis-
play shows the last value of average fuel
consumption from previous driving when
the engine switch is pressed to change the
ignition mode to "ON". Unless you reset
the value of average fuel consumption, the
display indicates the value of average fuel
consumption based on the average fuel
consumption during previous driving.
NOTE:
When you reconnect the negative (–) ter-
minal to the battery, the value of average
fuel consumption will be shown after driv-
ing for a period of time.
You can select when the value of average
fuel consumption is reset from among the
following two methods;
• Reset after refuel: the value of average
fuel consumption will be reset automati-
cally by refueling.
• Reset with trip meter A: the value of
average fuel consumption will be reset
automatically by resetting trip meter A.
To change when the value of average fuel
consumption is reset, refer to "Setting
mode" in this section.
NOTE:
If you add only a small amount of fuel
when you select "Reset after refuel", the
average fuel consumption value may not
be reset.
68PM2-01E