Suzuki Baleno Manual page 185

L (Low)
Use this position to provide maximum
power when climbing steep hills or driving
through deep snow or mud, or to provide
maximum engine braking when going
down steep hills.
NOTE:
If you move the gearshift lever to a lower
gear while driving faster than the maximum
allowable speed for the lower gear, the
transaxle will not actually downshift until
your speed drops below the maximum
speed for the lower gear.
NOTICE
Be sure to take the following precau-
tions to help avoid damage to the
CVT:
• Make sure that the vehicle is com-
pletely stationary before shifting
into "P" or "R".
• Do not shift from "P" or "N" to "R",
"D", or "L" when the engine is run-
ning above idle speed.
• Do not rev the engine with the tran-
saxle in a drive position ("R", "D",
or "L") and the front wheels not
moving.
• Do not use the accelerator to hold
the vehicle on a hill. Use the vehi-
cle's brakes.
If you cannot shift CVT gearshift
lever out of "P" (PARK)
Left hand drive vehicle
(1)
(2)
EXAMPLE
68PM00310
Vehicles with a CVT have an electrically
operated park-lock feature. If the vehicle's
battery is discharged, or there is some
other electrical failure, the CVT cannot be
shifted out of Park in the normal way. Jump
starting may correct the condition. If not,
follow the procedure described below. This
procedure will permit shifting the transaxle
out of Park.
OPERATING YOUR VEHICLE
1) Be sure the parking brake is firmly
applied.
2) If the engine is running, stop the
engine.
3) Make sure the key is in "ON" or "ACC"
position, or the ignition mode is "ON" or
"ACC".
4) Remove the cover (1) over the button.
5) With the release button (1) pushed by
the key or the flat end rod, push the
knob button (2) and shift the gearshift
lever to the desired position.
This procedure is for emergency use only.
If repeated use of this procedure is neces-
sary, or the procedure does not work as
described, take the vehicle to your dealer
for repair.
68PM2-01E
3-26