Suzuki Baleno Manual page 144

BEFORE DRIVING
To turn the lights on or off, twist the knob
on the end of the lever. There are four
positions:
OFF (1)
All lights are off.
AUTO (2)
This function works when the ignition
switch is turned to "ON" position or the
engine switch is pressed to change the
ignition mode to "ON". The headlights and
position lights are turned on and off auto-
matically according to the amount of out-
side light detected by a sensor. They go
out automatically when you turn the igni-
tion switch to "ACC" or "LOCK" position or
change the ignition mode to "ACC" or
"LOCK" by pressing the engine switch.
The light sensor (5) for sensing the amount
of outside light is installed on the passen-
ger's seat side Instrument panel.
2-125
CAUTION
If the light sensor area of the wind-
shield is covered with mud, ice, or
other similar substances, the head-
lights and position lights may be
turned on even when it is still light
outside. Before removing such sub-
stances from the windshield, always
set the wiper control lever to "OFF"
position. If the lever is left in "AUTO"
position, the wipers could unexpect-
edly operate and cause injury, and
could also be damaged.
NOTE:
• Avoid covering the light sensor area of
the windshield with a sticker. The sticker
may impair the performance of the sen-
sor and make the system unable to con-
trol operation of the lights correctly.
• If you turned the ignition switch to "ON"
position or changed the ignition mode to
"ON" by pressing the engine switch and
"AUTO" position remains selected, the
headlights and position lights come on
automatically as it gets dark outside,
even with the engine not running. Leav-
ing the lights lit for a long time may lead
to a completely discharged battery.
(3)
Front position lights, tail lights, license
plate light and instrument lights are on, but
headlights are off.
(4)
Front position lights, tail lights, license
plate light, instrument lights and headlights
are on.
EXAMPLE
68PM00230
With the headlights on, push the lever for-
ward to switch to the high beams (main
beams) or pull the lever toward you to
switch to the low beams. When the high
beams (main beams) are on, a light on the
instrument cluster will come on. To
momentarily activate the high beams (main
beams) as a passing signal, pull the lever
slightly toward you and release it when you
have completed the signal.
68PM2-01E