Suzuki Baleno Manual page 113

Selector position (for automatic
transaxle or CVT vehicles) / Gear-
shift indicator (if equipped)
EXAMPLE
(j)
68PM00255
Selector position
When the engine switch is pressed to
change the ignition mode to "ON", the dis-
play (D) indicates the gear position (j).
For details on how to use the transaxle,
refer to "Using transaxle" in the "OPERAT-
ING YOUR VEHICLE" section.
Gearshift indicator
Refer to "Gearshift indicator" in the
"OPERATING YOUR VEHICLE" section.
Trip meter
The display (E) shows the trip meter.
The trip meter can be used to measure the
distance traveled on short trips or between
fuel stops.
You can use trip meter A or trip meter B
independently.
To reset the trip meter to zero, push and
hold the trip meter selector knob (3) for
about 2 seconds when the display shows
the trip meter.
Odometer
The display (F) shows the odometer.
The odometer records the total distance
the vehicle has been driven.
NOTICE
Keep track of your odometer reading
and check the maintenance sched-
ule regularly for required services.
Increased wear or damage to certain
parts can result from failure to per-
form required services at the proper
mileage intervals.
BEFORE DRIVING
Setting mode
When the ignition mode is "ON" and the
vehicle is stationary, you can enter the set-
ting mode of the information display by
pushing and holding the indicator selector
knob (2) for more than 3 seconds.
• To select the setting that you want to
change, turn the indicator selector knob
(2) left or right.
• To change the setting, push the indicator
selector knob (2).
• To exit the setting mode, select "Back"
and push the indicator selector knob (2).
EXAMPLE
68PM00256
NOTE:
The currently selected setting item is sur-
rounded by a frame.
68PM2-01E
2-94