Suzuki Baleno Manual page 401

EXAMPLE
For maintenance-free battery (cap-less
type), you need not add water. For tradi-
tional type battery, which has water filler
caps, the level of the battery solution must
be kept between "MAX" and "MIN" level
lines at all times. If the level is found to be
below "MIN" level line, add distilled water
to "MAX" level line. You should periodically
check the battery, battery terminals, and
battery hold-down bracket for corrosion.
Remove corrosion using a stiff brush and
ammonia mixed with water, or baking soda
mixed with water. After removing corro-
sion, rinse with clean water.
If your vehicle is not going to be driven for
a month or longer, disconnect the cable
from the negative terminal of the battery to
help prevent discharge.
Replacement of the battery
(For vehicles without ENG A-STOP sys-
tem)
EXAMPLE
(3) (1)
(2)
54G118
(For vehicles with ENG A-STOP system)
EXAMPLE
(1)
(2)
INSPECTION AND MAINTENANCE
To remove the battery:
1) Disconnect the negative cable (1).
2) Disconnect the positive cable (2).
For vehicles without ENG A-STOP sys-
tem;
3) Remove the retainer nuts (3) and
remove the retainer (4).
For vehicles with ENG A-STOP system;
3) Remove the bracket bolt (3) and
remove the bracket (4).
(4)
4) Remove the battery.
To install the battery:
1) Install the battery in the reverse order of
removal.
2) Tighten the bracket bolt and battery
68PM00711
cables securely.
(4)
(3)
68PM00712
7-44
68PM2-01E