Lighting Control Lever - Suzuki Baleno Manual

BEFORE DRIVING
If either of odometer reading or time is
reached to the value which is set by the
system, this light comes on when the igni-
tion switch or engine switch is in "ON" posi-
tion. In addition, the "Oil" indication or
message is shown on the information dis-
play to tell you it is necessary to change
the engine oil and oil filter. When the
engine oil and oil filter are changed, and
the oil life monitoring system is reset, this
light will go out.
Whenever the engine oil and oil filter are
changed, the light must be reset to monitor
the next oil change timing properly. The
light will go out after the reset. For the
resetting procedure, refer to "Information
display" in this section.
NOTICE
Severe engine damage will result, if
you keep operating the engine after
this light comes on.
Change the engine oil and oil filter
immediately when the light blinks.
2-123
NOTE:
• This light is used to facilitate the oil and
oil filter change according to the mainte-
nance schedule.
• Even though the oil is replaced before
this light comes on, reset of the oil life
monitoring system is necessary. Consult
your SUZUKI dealer about the reset
method. If you reset it by yourself, refer
to "Setting mode" in this section.
Master warning indicator light
(For instrument cluster - Type C)
68PM00278
When the information display shows warn-
ing and indicator messages, this indicator
light may also blink.
For details, refer to "Information display" in
this section.

Lighting control lever

WARNING
To avoid possible injury, do not oper-
ate controls by reaching through the
steering wheel.
68PM2-01E
57L21128