Setup Mode Menu - GE AV-300i User Manual

3.1.3.1 Setup Mode Menu

Following menu will be activated by: STARTUP / Startup config / Enter setup mode
Startup config
Enter setup mode [c]
Drive data > Drive parameters
Mains voltage
Ambient temp
Switching freq
Spd ref/fbk res
Motor data > Motor parameters
Rated voltage
Rated frequency
Rated current
Rated speed
Rated power
Cosfi
Efficiency
Load default mot
CurrReg autotune > CurrentRegulator measurament
Start ?
Results
FluxReg autotune > FluxRegulator measurament
Shaft rotating
At standstill
Save setup > Save of the set and detected data
Save as?
Review setup > Recall saved setup files command
Exit setup mode > Exit Setup Mode command
Ch.3
252
GEH-6641E
STARTUP
the drive will reboot to SETUP MODE
SETUP MODE
> Main voltage
> Ambient temp
> PWM switching
> Speed resolution
> Motor cosphi
> Motor efficiency
> Load default motor
Standard 400V
Standard 460V
> Enable procedure
> Measurament results
Measured Rs > Stator resistance
Measured Rr > Rotor resistance
Measured Rr2 > Rotor resistance2
Measured DTs > Dead time limit
Measured DTL > Dead time slope
Measured LsSigma > Statoric inductance
> with moving Rotor
Start ? > Enable procedure
Results > Measurament results
Measured P1 flux
Measured P2 flux
Measured P3 flux
Measured ImNom
Measured ImMax
Measured FluxNom
Measured FluxMax
> with stopped Rotor
Start ?
> allows to select 4 files where 4 different motor setups can be saved
Setup 0 > motor setup File0
Setup 1 > motor setup File1
Setup 2 > motor setup File2
Setup 3 > motor setup File3
—————— Parameters & Pick Lists ——————
> P1 coeff. of flux curve
> P2 coeff. of flux curve
> P3 coeff. of flux curve
> value of the Rated magn. Curr.
> value of the Max magn. Curr.
> value of the Rated Flux
> value of the Max Flux
the drive will reboot to STATUS menu