Activity; Restart; Restart Time; Regulation Alarm Reset - GE AV-300i User Manual

1.12.5.2 Activity

With this parameter it is possible to set the action to be performed after the alarm intervention.
0 => Only msg alarmq
1 => Ignore
2 => Disable drive
3 => Stop
4 => Fast stop
5 => Curr limstop
6 => Warning
7 => Not allowed
msg :
State Machine commands :
Status:

1.12.5.3 Restart

With this parameter it is possible to enable the automatic start after the alarm cause has been removed.
0 => Off
1 => On

1.12.5.4 Restart Time

With this parameter it is possible to set a period of time, within which the alarm state has to be removed, in
order to perform an automatic start.

1.12.6 Regulation Alarm Reset

When a regulation alarm intervenes, the Drive reaches the alarm state. Such alarm state can be reset when the
alarms are no more active and the user performs a "Reset Alarm" command Transition 0=>1.
By using the Fault reset src source, it is possible to select the origin of the "reset" command signal (for example
a command via the terminal strip through a digital Input).
How to perform a "Reset Alarm" command:
Via the keypad:
Via the terminal strip:
Via Digital (Serial – Bus – Dgfc) :
N !
OTE
if the "Fault reset src" Pin is connected to a digital input, such input has to be kept at a low logic
state. If such state is high, the first "Fault reset" command via the Red key has no effect.
Ch.1
126
GEH-6641E
Actions: msg
Actions: none
Actions: msg –
Actions: msg –
Actions: msg –
Actions: msg –
Actions: msg –
Actions: msg –
The message has been sent to the alarm list and to the alarm config list.
A change in the drive state has been forced (alarm intervention).
The active alarm signal is immediately set; it is reset when the alarm is
nmore present and the state machine is not in an alarm condition.
by pressing the Red key.
connect the "Fault reset src" Pin to a digital input. Transition 0=>1.
connect the "Fault reset src" Pin to a bit of the decomposed word and
set the decomposed word. Transition 0=>1.
—————— Function Description ——————
commands for SM
commands for SM
commands for SM
commands for SM
Status
Status
– Status.
– Status.
– Status.
– Status.