Ramp Configuration (Ramp Config); Ramp Setpoint Block (Ramp Setpoint) - GE AV-300i User Manual

1.7 RAMP CONFIGURATION (RAMP CONFIG)

It is possible to select a Linear or S- shaped ramp.
Mlt ramp s0 src
0
Mlt ramp s1 src
0
Mlt ramp set 0 Mlt ramp set 0
Mlt ramp set 1
Mlt ramp set 2
Mlt ramp set 3
+
Analog input 1 out Ramp ref 1 src
(Default)
Ramp ref 3 src
Int ramp ref 2
Ramp ref 2 src
Ramp ref inv src
NULL

1.7.1 Ramp Setpoint Block (Ramp Setpoint)

The Function of this Block is to generate the speed Setpoint for the Ramp Block. A Setpoint is a Reference.
By algebraically adding its inputs, the Block generates the output Setpoint.
On the input the Block allows to select the origin of the sources: Ramp Ref 1 src and Ramp Ref 2 src are two
selectable references.
The internal value can be allocated in the Block configurations through the Int ramp ref 1 and Int ram ref 2 parameters.
Ramp Ref 3 src will be added to Ramp Ref 1 src. Defaul setting is connected to Moto potentiometer output.
Ramp Ref inv src allows to invert the whole output Setpoint. The output state is determined by a multiplier
according to the state of the connected signal.
The following references are connected together with the signals of the three input Sources: the output reference
of the Motopotentiometer Block and the output reference of the Multi Speed Block.
N !
OTE
Ramp ref 2 mon must be zero for the drive to stop without opening the enable input.
The inputs of this block are:
The outputs are:
Some Inputs and the Ramp Setpoint Output signal can be monitored.
AV-300i Version 2 User's Guide
MULTI RAMP
Mlt ramp sel m Scurve time set 0
CTRL
RAMP SETPOINT
NULL
+
NULL
+ +
NULL
+1
Ramp setpoint
-1
· Ramp Ref 1 src
· Ramp Ref 2 src
· Ramp Ref 3 src
· Ramp ref inv src
· Ramp setpoint
—————— Function Description ——————
RAMP CONFIG (factory setup)
RAMP FUNCTION
Ramp input=0
Ramp output=0
Ramp freeze
Ramp setpoint
Ramp shape Ramp out enable
Ramp out mon Speed setpoint input
Ch.1
83