GE AV-300i User Manual page 67

I/O CONFIG
The Block of the Analog input 1 is shown in the figure below (it is valid also for the input 2 and 3).
An inp 1 type
Terminal Input
An inp 1 src
AI 1 sgn src
AI 1 alt sel src
An inp 1 cfg
An inp 1 type
AI 1 alt value
An inp 1 thr
AV-300i Version 2 User's Guide
AI 1 sgn src
AI 1 alt sel src
An inp 1 cfg
An inp 1 type
AI 1 alt value
An inp 1 thr
An inp 1 scale
An inp 1 filter
An inp 1 lo lim
An inp 1 hi lim
AI 1 offs tune
AI 1 gain tune
An inp 1 mon
An inp 1 output
An inp 1 < thr
An inp 1 offset
An inp 1 gain
SAVE PARAMETERS
An inp 1 thr
+
X
+
An inp 1 offset
An inp 1 scale
It connects the selected signal to the selector of the multiplier input:
if the signal is 0, multiply by +1, or if the signal is 1, multiply by -1.
It connects the selected signal to the selector of the alternative reference.
It allows selection of the input type (+/- 10V, 0-10V... ...0-20mA,
4-20mA).
Alternative reference value in count.
Input threshold value in count.
—————— Function Description ——————
Start ?
Start ?
An inp 1 hi lim
* -1
* +1
An inp 1 lo lim
AI 1 sgn src AI 1 alt set src
An inp 1 < thr
An inp 1 output
AI 1 alt value
67
Ch.1