Status Menu; Quick Menu - GE AF-60 LP Programming Manual

Navigation Keys:
[Back]: For moving to the previous step or layer in the navigation structure.
Arrows [ ] [ ]: For maneuvering between parameter groups, parameters and within parameters.
[OK]: For selecting a parameter and for accepting changes to parameter settings.
Operation Keys:
A yellow light above the operation keys indicates the active key.
[Hand ]: Starts the motor and enables control of the frequency converter via the Keypad.
[Off/Reset]: The motor stops except in alarm mode. In that case the motor will be reset.
[Auto ]: The frequency converter is controlled either via control terminals or serial communication.
[Potentiometer] Keypad: The potentiometer works in two ways depending on the mode in which the frequency converter is running.
In Auto Mode the potentiometer acts as an extra programmable analog input.
In Hand Mode the potentiometer controls local reference.

3.2. Status Menu

After power up the Status Menu is active. Use the [MENU] key to toggle be-
tween Status, Quick Menu and Main Menu.
Arrows [ ] and [ ] toggles between the choices in each menu.
The display indicates the status mode with a small arrow above "Status".

3.3. Quick Menu

The Quick Menu gives easy access to the most frequently used parameters.
1. To enter the Quick Menu, press [MENU] key until indicator in display is placed above Quick Menu.
2.
Use [ ] [ ] to select either QM1 or QM2, then press [OK].
3.
Use [ ] [ ] to browse through the parameters in the Quick Menu.
4. Press [OK] to select a parameter.
5.
Use [ ] [ ] to change the value of a parameter setting.
6. Press [OK] to accept the change.
7. To exit, press either [Back] twice to enter Status, or press [Menu] once to enter Main Menu.
AF-60 LP™ Micro Drive Programming Guide
Illustration 3.8: Indicating Status mode
Illustration 3.9: Indicating Quick Menu mode
3
9