Cleaning And Maintenance - Fieldmann FDK 201302-E Instruction Manual

Replacement of carbon brushes
ATTENTION! In case of carbon brush seasoning, immediately switch off the saw and
contact the nearest service centre of FAST ČR, a.s. or your nearest vendor.
Use only correct types of carbon brushes.
After attaching new carbon brushes, let the saw run on idle for approx. 5 minutes.

. CLEANING AND MAINTENANCE

Keep the engine vent holes clean and dust-free.
If the circular-saw blade is damaged, replace it immediately by a new blade of the same type.
ATTENTION! Before cleaning and maintenance, always unplug the supply cable of the tool
from the socket.
The tool requires no special maintenance, just wipe the cover of the tool with a wet cloth on a
regular basis.
Clean the vent holes on a regular basis.
Never clean any part of the tool using a hard, sharp or rough object.
CLEANING AND MAINTENANCE TIPS
Store the tool, accessories and instructions for use in the original packaging to ensure you
always have all necessary parts and information.
If the tool is not used for a long time, do not store it in places with high temperatures.
If practicable, store the tool in a place with constant temperature and humidity.
Avoid contact of the tool with humidity and water. Follow the instructions specified in this
operating manual
ELECTRICAL CIRCULAR SAW OPERATING INSTRUCTIONS