Table of Contents
Advertisement
EN
14
Technical data | Cleaning and maintenance
7. TECHNICAL DATA
Mains voltage
Power input
Stroke speed
Cutting depth, wood
Cutting depth, iron
Cutting depth, metal pipe
Sound pressure level
Sound power level
Vibration level
8. CLEANING AND MAINTENANCE
Always pull out the mains power plug before starting any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with compressed air at low pressure.
We recommend that you clean the device immediately each time you have fi nished using it.
Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device.
Carbon brushes
In case of excessive sparking, have the carbon brushes checked only by a qualifi ed electrician.
IMPORTANT
The carbon brushes should not be rep laced by anyone but a qualifi ed electrician.
Maintenance
There are no parts inside the equipment which require additional maintenance.
710 W
-1
0–2800 min
115 mm
5 mm
60 mm
L
= 82. 1 dB (A), K
= 5 dB (A)
pA
pA
L
= 93. 1 dB (A), K
= 5 dB (A)
wA
wA
2
ah, B = 22.5 m/s
, K =1.5 m/s
2
FDPO 200711-E
Advertisement
Table of Contents
