Technical Data; Cleaning And Maintenance - Fieldmann FDPO 201050-E User Manual

EN 16 Technical data | Cleaning and maintenance

7. TECHNICAL DATA

Power
Voltage
Stroke length
Rated speed
1 pc of saw blade

8. CLEANING AND MAINTENANCE

Always pull out the mains power plug before starting any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with compressed air at low pressure.
We recommend that you clean the device immediately each time you have fi nished using it.
Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device.
Carbon brushes
In case of excessive sparking, have the carbon brushes checked only by a qualifi ed electrician.
IMPORTANT
The carbon brushes should not be rep laced by anyone but a qualifi ed electrician.
Maintenance
There are no parts inside the equipment which require additional maintenance.
1050W
230 240V 50/60Hz
25mm
1000–3000r/min
included
FDPO 201050-E