Maintenance And Storage - Fieldmann FZP 2002-E Manual

Notch
In order to make a notch, start with the cut of upper notch. Using bottom part of guide make a
cut within the 45° inclination in the right angle to the direction of planned fall.
Then make a lower notch so that it meets exactly the lower side of the upper notch.
Notch height should be approx. 1 /4 of tree diameter in the 45° angle.
The line of inner notch angle must be horizontal, namely exactly in the right angle to fall
direction.
Main („felling") cut
Felling cut is made from the rear part of tree and must also be horizontal.
Position yourself so that you have the tree at your left hand and make a cut with the lower part
of guide (chain pulling).
Place the main cut approx. 3-5 cm (1½ - 2") above the lower notch.
Make the cut while the saw runs at maximum revolutions. Slowly penetrate to the tree with
the saw. Pay attention to tree movement in the opposite direction than your required fall
direction. Insert a wedge or felling insert to the main cut once cut depth allows that.
After the cut is completed, the main cut has to be parallel with the notch and at the same time
a wood slice, so called remaining cut, with the minimum width of 1/10 of tree diameter must
be left.
The purpose of remaining cut is to serve as a piece securing required fall direction.
If a remaining cut is too small or was split or the notch and main cut did not meet, tree fall
direction is out of control.
If the main cut and notch correspond, the tree starts falling on its own or using the wedge or
felling insert.

14. MAINTENANCE AND STORAGE

ATTENTION! Always turn off motor before cleaning and maintenance!
Here are several instructions related to the maintenance of your chain saw. If you in any doubt as
to any of them, contact your service centre.
Check power cord and plug for any damage. Damaged cord or plug must be replaced.
Maintain ventilation holes clean and open.
Clean chain brake and secure its proper function.
Check the automatic lubrication system.
Check guide regularly from all sides. Check whether oil channel is clean. Clean guide groove.
Check chain tightening, teeth tips and chain operation (rotating).
Check sprocket state and in case of wear, it must be replaced.
Remove any wear at guide edges.
ELECTRICAL CHAIN SAW
Instructions for proper use | Maintenance and storage 25
OPERATING INSTRUCTIONS
EN