Welding Parameters Setting - Air Liquide SAF-FRO DVU W500 Instruction For Operation And Maintenance

EN
Manual wire speed advance :
To activate the wire speed advance, press and hold the button of manual wire speed advance. (I5).
The wire is fed with the lowest speed for 1s and then increases progressively up to the reference speed value.
Purge gas :
Are-press on the button (I7) stops the gas flow
The purge gas timing can be modified with the right encoder (4), the modification is taken into account during the next purge.

3.2. WELDING PARAMETERS SETTING

Setting interface presentation :
The wire feeder enables you to set the main welding parameters (wire speed, arc voltage, dynamism...) and the trigger mode. The other settings are
configured on the power source. See the User instructions of the power source.
Modifications made on the wire feeder (or the power source) are updated at the same time on the power source (or the wire feeder).
The wire speed is displayed and can be set with the left encoder (2) up to the limit of 12.5
m/min.
To activate the gas purge, press the button gas purge (I6). The gas flows during the defined
timing. The timer is displayed:
1 Line 2 of the LCD screen that displays the parameters being adjusted
2 Left encoder for setting the parameter displayed on the left
3 Scroll button ± of displayed parameters
4 Right encoder for setting the parameter displayed on the right
8