Air Liquide SAF-FRO DVU W500 Instruction For Operation And Maintenance page 11

EN
line 7
Transit time
Potentiometer settings
The wire feeder may be connected to:
•
The potentiometer remote command
•
The potentiometer torch
•
The compatible push pull torch with potentiometers
To be considered, the potentiometers must be configured into the power source (for more details see the power source instruction manual ). You have to
specify the number of used potentiometers.
The potentiometers tune:
Potentiometer 1
Potentiometer 2
The setting range of the potentiometers depends on the working mode or on the program limitations.
Only one peripheral with a potentiometer can be connected to the installation.
When the potentiometers are connected and activated, the corresponding parameters are not adjustable by digital interfaces
(wire feeder, generator and RC job)
MIG welding
In welding, the interface is automatically adapted and only the main welding parameters can be changed:
Wire speed, Arc length, Dynamism, Current, Voltage.
MMA welding
For more information about the setting of the MMA process, see the power source instruction manual.
line 1
Welding current
line 2
Setting of the arc striking dynamism
line 3
Last welding current measure
During welding, the interface is similar to the MIG process.
Wire speed
Arc Voltage
MMA Process
Post soudage
Dynamism setting
Last welding voltage measure
11