Wire Feeder Configuration - Air Liquide SAF-FRO DVU W500 Instruction For Operation And Maintenance

EN
The line 1 contains, in this order, the following information
•
Program status (optional)
•
Program number
•
Program name
The status information are:
Floppy = The program has been modified since the last save.
Verrou = Le programme est verrouillé.
If the name of the program exceeds the capacity of the display, the name characters are continually shifted to allow a complete reading.
Program selections :
Select a program by pressing the button + (14) to move to the next program, or the button - (13) to return to the previous program.
If a program list is active, the selection is limited to the programs of the list.
Restore and save the current program
Navigate to the function « restore » by pressing the button OK (15).
Turn the encoder (2) or (4) to point the arrow at the desired operation.
Confirm the selection by pressing to the button OK (15).
If you want to leave program, press any button other than OK (15) or the trigger button.

3.5. WIRE FEEDER CONFIGURATION

Warning messages :
When a fault occurs, the number and the text box information associated the fault are displayed.
When the fault disappears, associated message flashes. Then it can be acknowledged by pressing the button OK on the wire feeder or the power
source.
Once the fault is acknowledged, the message disappears.
For more information, see the power source instruction manual.
14