Air Liquide SAF-FRO DVU W500 Instruction For Operation And Maintenance page 9

EN
Out of welding MIG program setting
The scroll button ± (3) enables you to show the following lines in order to get access to the setting of the main welding parameters:
line 1
Working mode (SYN, MAN FREE)
line 2
Last welding current measure
line 3
Thickness setting
Line 4
Wire speed
line 5
For the working modes FREE or MAN, the lines 3 and 4 are replaced with these following lines:
Wire speed
The presentation of the main welding parameters may vary according to the phases of the welding cycle you have selected on the power source and to the arc
transfer you use.
The welding cycle setting is detailed in the instruction manual of the power source. In the following, the specific cases of the steps mode and the
Advanced Sequencer mode are presented as examples.
Arc transfer
not settable, for information
Post welding
Trigger mode
Last welding voltage measure
Welding current
Arc length
Dynamism correction
Arc voltage
9