Rational iCombi Pro Original Installation Instructions page 79

15 Accessories
A detailed overview with part numbers can be found in the accessories catalog.
Accessories
Stands UG I – XS
Left and right heat shield
Levelling frame for tabletop de-
vices
Device extension for tabletop
devices
Device extension for floor de-
vices
Transport trolley for support
rack trolleys (standard or
Combi-Duo)
Support rack trolley extension
Entry ramp for floor devices
Condensation breaker
Wall mount
80.06.083_iCombi Pro-iCombi Classic_IM_V01_en-US
Description
Different stands, with or without support rails for
storage of accessories and partially closed. The
stands can be extended with swivel castors or fixed
feet for varying installation variants.
If a sufficient distance to the heat source on the left
cannot be maintained, an additional heat shield is
available to reduce the thermal load.
For the device sizes 6 half size GN and 10 half size
GN, an additional heat shield is available for the right
side.
If the installation surface is not horizontal, this can be
compensated by a levelling frame. The adjustment
range is +/- 20 mm [3/4 inch].
Suitable for unit sizes 6 half size GN and 10 half size
GN with a depth of at least 700 mm [27.6 inches].
If the distance to the work surface is insufficient, the
unit can be raised by 150 mm [5.91 inches].
If the floor distance is too small for floor devices, the
distance can be increased by extending the device
feet by 70 mm [2.76 inch].
Recommended for use with support rack trolleys.
Two variants for tabletop devices (standard) or
Combi-Duo with different docking systems. Re-
quires the respective correct feed track. The standard
transport trolley is also available with height adjust-
ment to compensate for height differences during
installation.
If the feet of floor devices with a foot extension are
raised, a support rack trolley extension (70 mm [2.76
inch]) must be fitted to compensate for the support
rack trolley.
If the installation surface in the entry area of the sup-
port rack trolley is not horizontal for floor devices,
this can be compensated for by means of an entry
ramp. The adjustment range of the plate feet is +/-
10 mm [0.39 inch].
Extending the ventilation pipe without a condensa-
tion breaker can cause the unit to malfunction.
Installation of the condensation breaker and the in-
cluded pipes ensures that escaping steam can be di-
rected from the ventilation pipe to a non-critical
area / to the extraction region of an extraction sys-
tem.
Tabletop devices with device size XS GN and 6 half
size GN can be wall-mounted using a bracket.
15 | Accessories
79 / 84