Start-Up Procedures - Raven SmarTrax system Supplement Installation Manual

Manual # 016-0190-030 Rev A, 09/06
C
H A P T E R
6
S U P
TART- P ROCEDURES
After installing the SmarTrax on your machine, follow these start-up procedures.
Make sure the Steering Position Sensor does not over-extend or over-
compress when turning the wheels.
Turn the wheels fully from side to side numerous times to remove air
from the hydraulic system.
Time the wheels for full left to right and right to left time of approx.
6 seconds. Refer to the Universal Kit Manual for instructions on this.
Adjust the pressure switch to the most responsive setting. Refer to the
Universal Kit Manual for instructions on this.
13