Advertisement
After installing the SmarTrax on your machine, always follow these start-up pro-
cedures.
Make sure the Steering Position Sensor does not over-extend or over-
compress when turning the wheels.
Turn the wheels fully from side to side numerous times to remove air
from the hydraulic system.
Important:
left time of approximately 5 seconds. Refer to the Universal
Kit Manual for additional instructions on this.
Adjust the pressure switch to the most responsive setting. Refer to the
Universal Kit Manual for instructions on this.
S
U
TART-
Time the wheels for a full left to right and right to
Manual # 016-0190-006
C
H A P T E R
6
P
P
ROCEDURES
15
Advertisement
